System Modelling using Simulink (BECL657B)

System Modelling using Simulink

Course Code BECL657B
CIE Marks 50
Teaching Hours/Week (L:T:P: S) 0:0:2:0 
SEE Marks 50
Credits 01 
Total SEE+CIE 100
Exam Hours 2 
Examination type (SEE) Practical

Experiments

1 a) Generate the following signals using Simulink and display these signals on a single scope with separate inputs.

i) sinusoidal signal, ii)square signal, iii) sawtooth signal, and iv) random signal

b) Perform the following operations using simulink and display the output.

2 Solve the second order differential equations shown below using Simulink and display the output.

3 Design and realize the second order low pass and high pass RC filters using Simulink.

4 Design a BCD adder and use Simulink to simulate and verify its operation.

5 Design and Simulate the following using Simulink and verify its operation.

a) 3−bit Up / Down Counter, b) 4−bit Ring Counter

6 Design and simulate the 4x1 Multiplexer and 1x4 Demultiplexer using Simulink

7 Find the step response of the following system functions given below, using Simulink.

8 Realize the FIR filter given by the impulse response h(n) = {0.08, 0.21,0.54, 0.86, 1, 0.86, 0.54, 0.21 0.08) using Simulink. Obtain the frequency response characteristics.

9 Simulate the Amplitude Modulation and Demodulation using Simulink. Display the output signal and its spectrum.

10 Simulate the modulation & demodulation of a random binary data stream using QPSK using Simulink. Display the output signal and its spectrum. 

Suggested Learning Resources:

1. Steven T. Karris, “Introduction to Simulink® with Engineering Applications”, Orchard Publications, 2011, ISBN : 978-1934404218

2. Devendra K. Chaturvedi, “Modeling and Simulation of Systems Using MATLAB and Simulink”, CRC Press Taylor & Francis Group, 2010, ISBN 9780815351382